All machines require careful maintenance, and digital PVC cutting machines are no exception. Today, as a digital cutting system supplier, I would like to introduce to you the maintenance guide for digital cutting systems.
Standard operation of PVC cutting machine:
Following the official operating methods is also the basic step to ensure the long service life of the PVC cutting machine. Operating according to standards can reduce the failure rate of equipment.
When you turn off the main power button. Do not force shutdown or sudden power outage. When the machine is working naturally, if the power is suddenly cut off, components, especially the hard disk, will be damaged due to the recognition operation of the software that is quite hot.
Under normal circumstances, prevent bruises and avoid contamination by irritating and corrosive liquids. When you need to clean the casing, wipe it with a wrung-out damp cloth or use a soft cloth dipped in special detergent. Avoid sharp objects coming into contact with the housing. When switching the cutter head, be careful to insert and pull it gently to prevent accidental damage to the casing.
Pay attention to the working environment
It is recommended to place the PVC cutting machine in a place without direct sunlight or other heat radiation. Because the sun is too strong, the surface of the machine will overheat, which is not conducive to the maintenance of the machine. machine. In addition, the surrounding environment should not be too humid.
Excessive moisture will make the cutter easy to rust, the metal guide rail will be less protective, and the cutting speed will be reduced. Do not place it in places with excessive dust or corrosive gases, as these environments can easily damage the electronic components of the cutting machine, or cause poor contact or short circuit between components, thus affecting the normal operation of the equipment.
Regular machine maintenance
Perform regular maintenance according to the maintenance procedures and frequency in the instruction manual, and pay attention to the time for lubricating oil and cleaning equipment.
The dust on the machine tool and guide rails must be cleaned every working day, the bed must be kept clean, the air source and power supply must be turned off when leaving get off work, and the residual gas in the machine tool pipe must be evacuated.
If the machine is idle for a long time, please turn off the power to prevent unprofessional operation.
For more information, please consult:
Email: info@aolcnc.com
Phone: +86-531-88620680
WhatsApp/We Chat: 0086-18560162709
youtube: https://www.youtube.com/channel/UCDiNQSjBR5DsAX9QfkWF7AA
Website: https://www.aolcnc.com/
